GTCO Cordless Roll-Up - Users Guide - Manual (Page 43)

Cordless Roll-Up 43
Format Selection Commands, Cont.
Pushbutton Include
Pushbutton Exclude
Code: PI
Code: PE
Space Include
Space Exclude
Code: SI
Code: SE
Carriage Return Include
Carriage Return Exclude
Code: CI
Code: CE
Line Feed Include
Line Feed Exclude Code: LI
Code: LE
These commands control the presence of the corresponding characters in ASCII formats.
Pushbutton codes and where they appear in coordinates are described in the Advanced
Programming Information section. When included, the space is an additional character
separating the X and Y components of the coordinate data. When included, the LINE FEED
is an additional character following the .
Alarm Commands
Enable Alarm
Disable Alarm Code: AE
Code: AD
These commands enable or disable the audible alarm. When enabled, a short tone will
sound when a transducer switch is pressed. When disabled, the alarm will not sound in
response to transducer switch presses, but it may be sounded by remote commands and
will be active during diagnostics and in the menu modes.
Sound Tone
Tone Pause Code: T1
Code: T0
The Sound Tone command allows a remote device to sound the Cordless Roll-Up’s audible
alarm. Tone Pause provides a pause between tones. Tones and pauses are in 0.25 second
intervals. Tone commands are not affected by the Disable Alarm command.