FingerTec DiGiTime (OEM) - Manual (Page 82)

81 CONTENTS
Enable “Automatic append data to output file during data download” if you would like the
Software to append new downloaded clocking data into the same file during each of the
downloading. Click “Verify” to save settings.
Step 3: Click to define path to save the exported
file. Only enable “Append data to existing output
file” if you had enabled “Automatic append data to
output file during data download” in the previous
step. Click “Export” to start.
Step 4: You can check the contents of the export-
ed raw clocking data. Sample is shown above.
PURGE CLOCKING DATA FROM TERMINAL DATA AUDIT LIST
If you discovered that there are strange or improper clocking activities (wrong date, wrong
user ID etc), you can delete them. However, we strongly recommend you not to delete any
contents in the Terminal Data Audit List, as it is the main database of the software.
To delete clocking data, follow the steps below.
Step 1: Click to open Terminal Data Audit List.
Step 2: Click “Purge” to start deletion of clocking data.
Step 3: A new window will pop up. Select the user ID and define the date range to delete.
Click “Delete” to start.