FingerTec DiGiTime (OEM) User Manual

Page 11

Step 3:

Descriptions of Terminal Advanced Settings are explained below:

• Terminal ID:

Specify the terminal identification number.

• Model:

Choose from a list of the terminal models.

• Description:

Describe the terminal’s details for example terminal 1 location is at the front

entrance.

• Polling Host IP:

Retrieve and display the host IP. (Only a computer with this IP address can

download the data from the terminal.)

• No Attendance Records:

A check on this box will provide no attendance records at all. This

function is suitable for terminal for door access only.

• Language:

Choose the language for the terminal.

• Date format:

Choose the date format from the list for on the terminal.

• Voice;

Enable or disable voice emission in the terminal.

• 1:N Threshold:

Specify the value for 1:N matching threshold in the terminal, which means the

amount of total minutiae points that will be read by the scanner during verification. The valid

range of the threshold should be between 0-50; recommended range is 45-50.

• 1:1 Threshold:

specify the value for 1:1 matching threshold in the terminal. The valid range

should be between 0-50. Recommended range is 35-50.

• Only 1:1:

to specify the verification method for the terminal. If “No” is chosen, the terminal

will work on 1:N as well as 1:1 methods. If “Yes” is chosen, the scanner will not respond to a

fingerprint input unless the user inputs his/her ID.

• Idle Minute:

Specify the number of minutes to trigger the idle action with either power off or

sleep mode. Choose value “0” to disable this function.

• Idle Action:

Specify the idle action with either power off or sleep mode.

• Lock delay:

Specify the timer of the door after verification is done and before the door is shut

again. This function is for door access only.

• Wiegand format:

Specify the Wiegand format used. This is only used when you are using a

WG model. Wiegand format is another communication interface besides ethernet, RS232