HP LaserJet 4610n - Manual (Page 161)

Control panel message Description Recommended action
REPLACE FUSER KIT
For help press
The fuser kit has reached the end of its
life. Printing will not continue until the
fuser has been replaced. 1. Open the top cover.
2. Loosen the blue thumb screws.
3. Remove the old fuser unit.
4. Install a new fuser unit and secure
with thumb screws.
5. Close the top cover.
NOTE
If you want to continue printing past the
end-of-life message, the fuser kit count
must be reset using the printer control
panel. Please note that the end-of-life
message is provided as a customer
service, and printing past it is likely to
result in print quality degradation in the
near future. Once the fuser kit count has
been reset after an end-of-life message,
feedback on the kit's remaining life will
be incorrect until the kit is replaced and
the count is reset again.
To reset the fuser count
1. Press M
ENU
to enter the MENUS.
2. Press and to highlight
CONFIGURE DEVICE.
3. Press to select CONFIGURE
DEVICE.
4. Press and to highlight RESETS.
5. Press to select RESETS.
6. Press and to highlight RESET
SUPPLIES.
7. Press to select RESET SUPPLIES.
8. Press and to highlight NEW
FUSER KIT.
9. Press to select NEW FUSER KIT.
10. Press and to highlight YES.
11. Press to select YES.
The fuser count is reset and the printer
is ready to use.
Control panel messages (continued)
ENWW Control panel messages 149