beautypg.com

Comtrol AT Commands for SmartACFL User Manual

Page 73

background image

Command Reference Manual

100722A

Conexant

3-53

Reporting Selected Options
The modem reports the selected options in response to the following command:

+ESA?

The response is:

+ESA: ,,,,,,,

Example:

+ESA?
+ESA: 0,0,0, ,0,0,255,

For the defaults.

Reporting Supported Options
The modem reports the supported options in response to the following command:

+ESA=?

The response is:

+ESA: (list of supported values), (list of supported values),
(list of supported values), (list of supported values),
(list of supported values), (list of supported values),
(list of supported values), (list of supported values)

Example:

+ESA=?
+ESA: (0),(0),(0-1), ,(0-1),(0),(255),

3.2.8.2 +H - Enable/Disable RPI and Host DSVD
This command enables or disables Conexant Protocol Interface (RPI) processing and sets the DTE speed.

Syntax

+H=

Defined Values

Decimal number corresponding to the selected option.

0

Disable protocol interface and video ready mode.

1

Enable RPI mode and set DTE speed to 19200 bps.

2

Enable RPI mode and set DTE speed to 38400 bps.

3

Enable RPI mode and set DTE speed to 57600 bps.

11

Enable RPI+ mode. When in RPI+ mode, a link is established between the modem
and the WinRPI or WinRPI95 host PC software driver to allow the modem to
support protocol (V.42bis/LAP-M/MNP2-5) connections with a remote modem. This
command should only be used when the WinRPI or WinRPI95 driver software is
installed in the PC.

16

Reserved.

17

Reserved.

Result Codes

OK

0 to 3, 11, 16, 17

ERROR

Otherwise.

This manual is related to the following products: