Comtrol AT Commands for SmartACFL - Manual (Page 169)

Command Reference Manual
100722A Conexant 7-25
S3 - Carriage Return Character ............................................. 3-66
S30 - Disconnect Inactivity Timer........................................... 3-72
S31 - Bit Mapped Options Status........................................... 3-72
S36 - LAPM Failure Control ................................................... 3-72
S38 - Delay Before Forced Hang Up...................................... 3-73
S39 - Flow Control Bit Mapped Options Status ...................... 3-73
S4 - Line Feed Character....................................................... 3-66
S40 - General Bit Mapped Options Status ............................. 3-73
S41 - General Bit Mapped Options Status ............................. 3-74
S46 - Data Compression Control ........................................... 3-74
S48 - V.42 Negotiation Control .............................................. 3-74
S5 - Backspace Character ..................................................... 3-66
S6 - Wait Time before Blind Dialing or for Dial Tone.............. 3-67
S7 - Wait Time for Carrier, Silence, or Dial Tone ................... 3-67
S8 - Pause Time For Dial Delay............................................. 3-67
S86 - Call Failure Reason Code............................................. 3-75
S9 - Carrier Detect Response Time ....................................... 3-67
S91 - PSTN Transmit Attenuation Level ................................ 3-76
S92 - Fax Transmit Attenuation Level .................................... 3-76
S95 - Extended Result Codes Control.................................... 3-76 -SMS= - Select Mode ...............................................................3-4
–STE= - Set Telephony Extension..........................................3-33
T
T - Set Tone Dial Default ........................................................3-26
V
V - Result Code Form.............................................................3-13
\V - Single Line Connect Message Enable..............................3-31
W
W - Connect Message Control................................................3-13
X
X - Extended Result Codes ....................................................3-14
Z
Z - Soft Reset and Restore Profile............................................3-1