beautypg.com

Comtrol AT Commands for SmartACFL User Manual

Page 113

background image

Command Reference Manual

100722A

Conexant

4-7

4.2.2.6 +FRM - Receive Facsimile
This command causes the modem to enter the receiver mode using the modulation defined below.

Syntax

+FRM=

Defined Values

Decimal number corresponding to the selected modulation mode and data rates shown in Table
4-2.

Reporting Current or Selected Values
Command: +FRM?
Response:

+FRM:

Example:

+FRM: 98

For V.17 9600 bps.

Reporting Supported Range of Parameter Values
Command: +FRM=?
Response:

+FRM: ( range)

Example:

+FRM: 3,24,48,72,73,74,96,97,98,121,122,145,146

Result Codes

CONNECT

Reported when the selected carrier is detected.

+FCERROR

Reported if another carrier is detected and FAR=0; the modem then returns to the command state.

NO CARRIER

Reported if loss-of-carrier is detected.

OK

Reported if the DTE sends any character to the modem other than XON or XOFF while operating
in configured flow control from the DTE; the modem then returns to the command state.

This manual is related to the following products: