Comtrol AT Commands for SmartACFL User Manual
Page 62

Command Reference Manual
3-42
Conexant
100722A
Examples
+ES=6
Enable V.80 Synchronous Access Mode originator.
+ES=,,8
Enable V.80 Synchronous Access Mode answerer.
+ES=6,,8
Enable V.80 Synchronous Access Mode originator and answerer.
+ES=3
Enable V.42 with Detection Phase originator. Disable V.80 Synchronous Access Mode originator.
+ES=,,2
Allow LAPM, MNP, or Normal Mode connection answerer. Disable V.80 Synchronous Access
Mode answerer.
+ES=3,,2
Enable V.42 with Detection Phase originator, allow LAPM, MNP, or Normal Mode connection
answer. Disable Synchronous Access Mode originator and answerer.
Reporting Current or Selected Values
Command: +ES?
Response:
+ES:
Example:
+ES: 3,0,2
For default settings.
+ES: 6,0,8
For V.80 Synchronous Access Mode originator and answerer.
Reporting Supported Range of Parameter Values
Command: +ES=?
Response:
+ES: (
Example:
+ES: (0-4,6,7),(0-4),(0-6,8,9)
3.2.5.2 +EB - Break Handling in Error Control Operation
This extended-format compound parameter controls the break handling in V.42 operation. It accepts three numeric
subparameters:
Syntax
+EB=[
Defined Values
Decimal number 0 specifying that break is to be ignored, i.e., not signaled to remote DCE.
Decimal number 0 specifying that any transmitted V.42 L-SIGNAL will not indicate break signal
length
Decimal number 0 specifying that break is not delivered to the DTE.
Reporting Current or Selected Values
Command: +EB?
Response:
+EB:
Example:
+EB: 0,0,0
For default settings.