beautypg.com

Comtrol AT Commands for SmartACFL User Manual

Page 131

background image

Command Reference Manual

100722A

Conexant

5-9

5.3.5

+FDR - Begin or Continue Phase C Receive Data

Syntax:

+FDR

Default value:

3 seconds in some places

The +FDR command initiates transition to Phase C data reception. This can occur after answering, dialing, a document is
received, or a page is received.

The DCE reports the negotiated T.30 parameters, with the remote ID information if available. When the DCE is ready to
commence data transfer, it issues a CONNECT response code. If the DCE cannot resume data transfer because there is no
more data, it responds OK. When the DTE is ready to accept data, it issues an character (018) to the DCE.

If the DTE issues an character to the DCE for flow control, the DCE signals the DTE when its buffers are empty by
sending a (<016><018>) character pair.

When the DCE delivers the last byte of a page, the DCE reports the Page Transfer Status via the +FPTS: response
(Table 5-4).

After a Page Transfer Status Report, the DCE reports the post page message from the remote facsimile station via the
+FET: response (Table 5-3) which signals the intentions of the remote station.

The DCE holds the post page response message to the remote facsimile station (MCF, etc.), represented in the +FPTS
parameter until the next +FDR command. The DTE may modify the +FPTS parameter before issuing the +FDR command
which releases that message. The DTE must issue a +FDR command to release Post Page Messages.

5.3.5.1 Initiate Document Reception
The +FDR command may be issued in Phase B after an answer command, or in Phase B after a previous document.

The DCE response in stream mode is:

+FCFR

when CFR sent

[+FTSI:]

if new TSI received

+FDCS:]

if new DCS

CONNECT
( needed from DTE here)


+FPTS:, [,, ]
+FET:
OK
(DTE must issue +FDR command to release post page response)

This manual is related to the following products: