Comtrol AT Commands for SmartACFL User Manual
Page 130

Command Reference Manual
5-8
Conexant
100722A
5.3.4
+FET - Transmit Page Punctuation
Syntax:
+FET=
DCE response:
+FPTS:
- when receive from remote OK
This command is used to punctuate page and document transmission after one or more +FDT commands. This command
generates T.30 Post Page Messages selected by the
The +FET=
indicates whether there are any additional pages are to be sent and, if so, whether there is a change in any of the document
parameters.
The DTE can command the DCE to generate PRI-Q messages with the +FET=
5-3).
This command must be sent within the time out specified by +FPHCTO after sending Phase C data, or else the DCE will end
the page and document transmission. If the Phase C timeout is reached, the DCE sends an EOP post page message and
terminates the session.
The remote facsimile station should respond to the post page message with a post page response. The DCE will report this
using the +FPTS:
5.3.4.1 End a Page
The +FET= command causes the DCE to append an RTC (6 EOL) pattern as needed and enter Phase D by sending the
selected T.30 Post Page message.
The +FET=1 (EOM) command signals the remote station that the next document will have a new DCS negotiated; this causes
the session to re-enter Phase B.
Table 5-3. T.30 Post Page Message Codes
ppm Code
Mnemonic
Description
0
[PPS-]MPS
Another page next, same document
1
[PPS-]EOM
Another document next
2
[PPS-]EOP
No more pages or documents
3
PPS-NULL
Another partial page next
4
[PPS-]PRI-MPS
Another page, procedure interrupt
5
[PPS-]PRI-EOM
Another doc., procedure interrupt
6
[PPS-]PRI-EOP
All done, procedure interrupt
=8+ppm
Post Page Message (ppm code)
Table 5-4. T.30 Post Page Response Messages
ppr Code
Mnemonic
Description
1
MCF
Page good
2
RTN
Page bad; retrain requested
3
RTP
Page good; retrain requested
4
PIN
Page bad; interrupt requested
5
PIP
Page good; interrupt requested