Comtrol AT Commands for SmartACFL User Manual
Page 136

Command Reference Manual
5-14
Conexant
100722A
5.4.7
+FPTS: - Receive Page Transfer Status
Syntax:
+FPTS:
The +FPTS:
The
values.
The receiving DCE will count the lines. These values are;
A receiving DTE may inspect 5.4.8 +FET: - Post Page Message Response Syntax: +FET: The +FET: 5.4.9 +FPTS: - Transmit Page Transfer Status Syntax: +FPTS: The +FPTS: response reports a The +FPTS: 5.4.10 +FHNG: - Call Termination with Status Syntax: +FHNG: +FHNG indicates that the call has been terminated. The hangup cause is reported and stored in the +FAXERR parameter for +FHNG: Upon termination of a call, the DCE determines the cause of termination and reports it as part of the FHNG: The hangup values are organized according to the phases of the facsimile transaction as defined by T.30. In the Figure The table values are in decimal notation. Leading zero characters are optional.
corresponding Post Page Response message until released by a +FDR command from the DTE.
the post-page message from the transmitting station. The +FET:
command. The
received from the remote DCE. The valid
later inspection. The
followed by the OK final result code.
It also stores this
A/T.30 flow charts, there are decision boxes labeled “Command Received?"; this is referred to as COMREC in the table.
Similarly, decision boxes labeled `Response Received?' are referred to as RSPREC in the table. A COMREC error or
RSPREC error indicates that one of two events occurred: 1) a DCN (disconnect) signal was received, or 2) an FCS error was
detected and the incoming signal was still present after 3 seconds. (See Figure A/T.30).