beautypg.com

Comtrol AT Commands for SmartACFL User Manual

Page 114

background image

Command Reference Manual

4-8

Conexant

100722A

4.2.2.7 +FTH - Transmit Data with HDLC Framing
This command causes the modem to transmit data using HDLC protocol and the modulation defined below.

Syntax

+FTH=

Defined Values

Decimal number corresponding to the selected modulation mode and data rates shown in Table
4-2.

Result Codes

CONNECT

Reported for either of two conditions:

1. At the beginning of transmission of the training pattern for the selected modulation.
2. If the Final Frame bit is 0.

OK

Reported for either of two conditions:

1. If the Final Frame Bit is 1.
2. if the DTE sends only (a null frame) while transmitting flags.

ERROR

Reported if five seconds elapse from the time when the modem reported the CONNECT result
code without any additional data transmitted from the DTE; the modem then turns off carrier and
returns to the command mode.

Reporting Current or Selected Values
Command: +FTH?
Response:

+FTH:

Example:

+FTH: 98

For V.17 9600 bps.

Reporting Supported Range of Parameter Values
Command: +FTH?
Response:

+FTH?

Example:

+FTH: 98

For V.17 9600 bps.

This manual is related to the following products: