2 commands and parameters – Comtrol AT Commands for SmartACFL User Manual
Page 110

Command Reference Manual
4-4
Conexant
100722A
4.2
COMMANDS AND PARAMETERS
4.2.1
Mode Entry Commands
4.2.1.1 +FCLASS=1 - Select Facsimile Class 1 Mode
+FCLASS=1 selects the Fax Class 1 Mode. The Fax Class 1 Mode commands and responses described in this section are
applicable when command +FCLASS=1 as shown in Table 4-1. (See Section 3.2.1.2 for the definition of the FCLASS
command.)
4.2.1.2 +FCLASS=1.0 - Select Facsimile Class 1.0 Mode
+FCLASS=1.0 selects the Fax Class 1.0. The Fax Class 1.0 Mode commands and responses described in this section are
applicable when command +FCLASS=1.0 as shown in Table 4-1. (See Section 3.2.1.2 for the definition of the FCLASS
command.)
4.2.2 Mode
Commands
4.2.2.1 +FAA - Auto Answer Enable
This command enables or disables fax adaptive answer. This command operates identically to the +FAE command.
Syntax
+FAA=
Defined Values
Decimal number corresponding to the selected option.
0
Disable data /fax auto answer mode. (Default.)
1
Enable data /fax auto answer mode. The modem determines the calling type and
issues DATA result code (13) if the caller is a data modem or issues FAX result
code (15) if the caller is a fax modem.
4.2.2.2 +FAE - Auto Answer Enable
This command enables or disables fax adaptive answer. This command operates identically to the +FAA command.
Syntax
+FAE=
Defined Values
Decimal number corresponding to the selected option.
0
Disable data /fax auto answer mode. (Default.)
0
Enable data /fax auto answer mode. The modem determines the calling type and
issues DATA result code (13) if the caller is a data modem or issues FAX result
code (15) if the caller is a fax modem.
After a data (not fax) connection is achieved (indicated by the DATA result code), the DTE must issue an ATO command to
cause the modem to go on-line.