Comtrol AT Commands for SmartACFL User Manual
Page 154

Command Reference Manual
6-10
Conexant
100722A
6.2.2.8 +VLS - Analog Source/Destination Selection
This command causes the modem to select one or more source/destinations of the analog data.
Syntax
+VLS=
Defined Values
Decimal number corresponding to the selected analog source/destination hardware configuration
(see Table 6-5).
Command: +VLS?
Response:
Example:
0
For the default setting.
Reporting Supported Range of Parameter Values
Command: +VLS=?
Response:
Where each event subparameter is a hex number the represents an event bit field of the reporting capabilities of each state.
(see Table 6-6):
Identifies the modem analog source/destination hardware configuration
A
capabilities for the Voice Transmit State, Voice Receive State, and the Voice Command State,
respectively. Each of the event reporting subparameters is a hex number that represents an event
bit field. The hex number format is defined in Table 6-6); a one in the bit field indicates that the
DCE can report the associated event.
Each of the possible hardware configurations has its own
Example:
AT+VLS=?
0,"",B0804100,B0804100,B0804100
1,"T",0B8433C1,0FE431C1,0B8431C1
2,"L",08800300,0CE00100,08800100
3,"LT",0B8433C1,0FE431C1,0B8431C1
4,"S",00800300,04E00100,20800100
5,"ST",0B8433C1,0FE431C1,0B8431C1
8,"S1",00800300, 04E00100,20800100
9,"S1T",0B8433C1,0FE431C1,0B8431C1
11,"M1",00800300,04E00100,20800100
14,"H",00800300,04E00100,20800100
18,"M1S",00800300,04E00100,20800100
19,"M1S1",00800300,04E00100,20800100
Result Codes
OK
ERROR
The