Introduction, 1 overview – Comtrol AT Commands for SmartACFL User Manual
Page 11

Command Reference Manual
100722A
Conexant
1-1
1. INTRODUCTION
1.1 OVERVIEW
This manual describes the host command and responses for the following Conexant modem families:
SmartSCM™ Modem Device Set
SmartACF™ Modem Device Set
SmartACFL™ Modem Device Set
The commands and responses are implemented in controller firmware for specific modem models. Additional configuration
and implementation information is available in release notes and/or readme files that accompany product firmware release.
The descriptions in this manual apply to all commands and parameters that may be supported by different modem models.
Refer to Modem Firmware Release notes for commands applicable to specific modem models.
1.1.1 Command
Syntax
The fundamental DTE interface command syntax is described in Section 2.
1.1.2 Command
Descriptions
Commands are grouped into the following categories:
Syntax and procedures
Section 2
Data commands
Section 3
Fax Class 1 and Fax Class 1.0 commands
Section 5
Fax Class 2 commands
Section 6
Voice/Audio commands
Section 7
1.1.3
Call Progress and Blacklisting Parameters
The SmartACF and SmartACFL modem MCU firmware may be provided either in reconfigurable form or preconfigured form.
Consult the specific firmware release notes for exact configuration information.
Reconfigurable Form. The modem MCU firmware can be configured for operation in specific countries by the PC-compatible
ConfigurACE II program. The call progress and blacklisting parameters described in the ConfigurACE II User's Manual can be
altered and loaded for a number of countries by this program.
Preconfigured Form. Specific MCU firmware configurations may be released that can be directly installed without requiring
the use of ConfigurACE II.