Toshiba TEC MA-315-100 - Manual (Page 88)

EO1-11069
Validation Print VALI
DATE
(Validation Key)
To perform a validation print of a sale item or a media entry, insert a validation slip to the
Validation Slot and depress this key. The sale item or media data just entered is printed on the
slip. Withdraw the slip to go on any other operation.
MGR
REG
0^^
SET
B
N0TE1
A required sale
item or media is
entered.
Insert a slip to
the Validation
Slot. (See the
sketch below.)
VALI
DATE
NOTES 1.
2
.
3.
4.
On this register, depressing the [VALIDATE] key will execute printing regardless of
presencelabsence of a slip. Se/bre depressing the key, be certain to insert a silip to the
Validation Slot. (If no slip is inserted, the validation print will occur over the last printed
line on the receipt)
After validation print, be certain to remove the slip from the Validation Slot
The number of validation print operations are processed into the Validation counter in the
report memory.
The following options are selective in relation to validation print (Refer to Chapter "22.
System Option Setting*’. Also reter to the print format on the next page.):
1) Non-print Selection (Address 12)
Consecutive No. Non-print (Bit 2) ... Initial Status: Print
Cashier ID Non-print (Bit 3) ... Initial Status: Print
2) Number of times for validation print of the same item (Address 12 • Bit 1)
Single-validation (only once allowed) (initial status), or
Multi-validation (any number of times allowed)
3) Validation Print Content after each non-cash media tender
(Addresses 7 to 10)
Sate Total Print, or Tendered Amount Print (Bit 2)
Initial Status for each Media:
[CHK TND] ... Tendered Amount Print
[Chg] ... Sale Total Print
[MISC] ... Tendered Amount Print
[CPN] ... Tendered Amount Print
(In case of a short-fender, the tendered amount is always printed regardless of
the status selection above.)
- 8 6 -