Toshiba TEC MA-315-100 - Manual (Page 41)

E01-11069
Clearing Errors, or Clearing Wrong Declaration
Key or Wrong Numeric Entries
(Clear Key)
When in sale entries an error has occurred with an alarm buzzer (beeps for about 2 seconds
only), a wrong Declaration Key (such as [RTNMDSE], [TX/M], [GST/M], etc.) has been
depressed, or a wrong numeric data has been entered; depress the [C] key.
1) Error has occurred (the
a l a r m b u z z e r i s
g e n e r a t e d a n d t h e
“ALM” lamp illuminates),
and the k e y b o a r d i s
locked.
2) D e c l a r a t i o n K e y h a s
been depressed.
ex.)
RTN
MDSE
3) N u m e r i c K e y s a r e
entered.
ex.)
4) Declaration Key(s)
+ Numeric Keys
The error condition is cleared (the
buzzer tone stops and the ‘‘ALM”
lamp is extinguished). Find the cause
of the error, and do the operation
again. Refer to "Possible Cause of
Error” attached where an error may
occur in each operation sequence on
the following procedure.
ex.)
5) Numeric Keys + Non-
motorized Key (key that
does not trigger printing)
ex.)
Q
The entered data are all cleared at
once.
6) Combination of 2) to 5) J
7) Combination of 6) + 1)
The entered data are all cleared at
once, and the error condition is
cleared also. Refer to 1) for finding
the cause of error.
NOTE: When data is already entered and printed (through a Department Key, etc.), it cannot be
cleared by the [C] key any longer. In need of deleting such data, see the Allowing:
Item Correction (Last Line Voiding) ITEM
CORR
Void (Designated Line Voiding)
All Void (Transaction Cancel)
Operations in “El” Mode
VOID
page 63
page 65
page 66
Chapter 20 (page 91)
- 3 9 -