Toshiba TEC MA-315-100 - Manual (Page 39)

EO1-11069
2. ff the [LOG/RECEtPT] key is simply depressed without a prior numeric enUy or widt
only any Declaration Key (such as [RTN MDSE]), the Receipt ON/OFF kincdon is
activated (refer to “Receipt-issue/Non-issue Selection” in the next Chapter) but not
Sign ON/OFF,
Sign ON Receipt Format Sian OFF Receipt Format
Thank you Thank you
Call again Call again
^Cashier Code
1 1 . - 0 3 . - 9 2
(1 to 8)
1 1 . - 0 3 . - 9 2
N « 1 1 ^ 3 0 0 No 1 1 z 3 0
★ ★ 1 CL
^ The signed-ON
Cashier Code is
printed on every s^e
★ ★ 0 CL
0 1 0.1 let receipt 0 1 3 . 6
0 9 - 1 0
(The Secret Code
portion is never
1 0 - 4 6
.Sign OFF Code
(always 0)
printed.)
(2) Cashier Lock Method This method is applied when two barrel locks are
installed as cashier locks. A maximum of 4 cashiers
can be identified in this method.
XT)‘
Cashier Keys 1 to 4
Each key (1 to 4) is assigned to each cashier. The
register will not operate in the REG, MGR, or S mode
unless of these keys is inserted and turned to the
position (1 to 4) corresponding to the Cashier Key No.
Each of the keys may be inserted and pulled out in
the neutral position marked with a dot. When the
operating cashier changes to another, the first Cashier
Key must be pulled out before inserting another
Cashier Key.
NOTES 1.
2 .
W hen this method is adopted, the signing function ("LOG” function) of the
[LOG/RECEtPT] key is deactivated. Accordingly, the key is only used as Receipt
ON/OFF switch.
No receipts are issued on turning ON or OFF a Cashier Key. However, the Cashier
Code (1 to 4) is printed near the bottom of every receipt to be issued.
(3) Cashier Push Key Method
This method is applied when four push-stay-down
keys are installed as cashier keys.
Each key (1 to 4) is assigned to each cashier. The
register will not operate in the REG, MGR, or □
mode unless of these keys is pushed held down.
NOTE: The "NOTES 1 and 2” attached to Method (2) above are also applicable to Method (3).
- 3 7 -