Toshiba TEC MA-315-100 - Manual (Page 115)

EOI >11069
Address:
([AT/TL] Key Function)
j Initial SET Bit Nos. i p
Your Selection ►
Bit
No.
Content
Selective Status
RESET SET
1
Tender and Total Functions in finalizing
a sale
r TENDER or TOTAL ~'\
L.
------------------- i
TENDER only
............................................. ;
.^mM.LUL......
SuDDlemehtarv Description:
B i t i : RESET status .
SET status
The key functions as Tender Key with a prior amount entry or as
Total Key without any amount entry.
The key always requires a tender amount entry.
Address:
j initial set Bit Nos. j ^
([CHK TND] Key Function) Your Selection................ ..
□
1
□
Bit
No.
Content
Selective Status
RESET SET
1
Tender and Total Functions in finalizing
a sale
TENDER or TOTAL i TENDER only j
2
Validation Print Content on Over-
tendering
SALE TOTAL rTENDERED AMOUN t I
3
Cashing with no purchase, using this
key.
PROHIBITED r ALLOWED "Ì
4
Over-tendering (tendering an amount
larger than the sale total, resulting in
calculation of change due)
i ALLOWED I
L. ____________________ i
PROHIBITED
_ _ _ _ _ _ _ _ _ _ _ I
____________ _
SuDolementarv Description:
Bit 1 : Refer to the “Supplementary Description” of Bit 1 attached to Address 6 above.
BIT 2: RESET status ... Prints the sale total amount.
SET status ... Prints the tendered amount.
In case of a short-tender, the tendered amount is always printed regardless of this bit
status selection.
Bit 3; RESET status ... Customers’ checks cannot be cashed outside a sale.
SET status ... Customers’ checks can be cashed with no purchase outside a sale.
Bit 4: This Bit status selection is effective only in tendering operation.
SET status ... If this bit is SET and also Address 11 - Bit 1 is SET (for Short­
tendering Prohibited), an amount equal to the sale total is always
required for tendering.
113 -