I introduction, Installation, To set up the surround speakers – Toshiba TW56D90 User Manual
Page 6: Connection, Mounting position
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHAPTER 1
I
INTRODUCTION
Installation
{continued)
• The Surround Speakers are packed in a separate box inside this container. Unpack the Speakers
carefully and set them up as shown below.
To set up the Surround Speakers
TV rear
1
C o n n e c tio n
1
Connect one end of the
speaker cable to the
terminals on the Surround
Speaker.
Connect the other end of the speaker
cable to the "REAR SPEAKER"
terminals* * on the TV rear panel.
While depressing the button, insert
the cable. Then, release the button.
♦Note;
The REAR SPEAKER terminals can
be used only for the supplied
speakers.
Do not connect any other speakers to
these terminals.
Connect another speaker following
steps 1 and
2
above.
M o u n tin g p o s itio n
To enjoy the sound of the DSP Surround or Dolby Pro
Logic Surround features, you must mount the speakers
to the left and right, on a shelf or on a wall behind your
normal viewing position. See page 39 for details.
Note;
You can get the best surround performance when you
install the speakers slightly above your viewing position
while watching TV.
CAUTIONS
* If the speakers are mounted on a wall, hang them
from the opening provided on their back panels.
• Care should be taken when choosing speaker
mounting hardware to insure compatibility with the
material of the wall. Do not use mounting hardware
with thin and/or soft wall materials, as the speaker
may fall and cause personal injury or be damaged.
L speaker
R speaker