Toshiba TW56D90 - Manual (Page 18)

I
CHAPTER 1 INTRODUCTION
Using the Remote Control
(continued)
• This Remote Control is capable of learning operating codes from most infrared remote
control transmitters. You can control the functions of your TV and a variety of video/
audio equipment with the supplied Remote Control only.
• The 31 buttons can be used as Learning buttons. {See page 13.)
To program the Remote Control (continued)
To learn operating code of another remote control
1 Set the Mode selection switch to AUX.
6 5" S'
’oC-t' tV/ViPEO B^Li
)
Set the LEARN-USE switch to LEARN.
' TIUSE LEARN
Place the supplied Remote Control and the remote
control transmitter to be learned, head to head
approximately 1 to 3 inches (3 to 8cm) apart.
iO-QD
Head to head □ Q
1-3 inches apart
□ a
IQ
Supplied Remote Control Remote to be learned
Hold down the button to learn on the supplied
Remote Control for about 1 second until the
LEARN indicator lights up.
Note:
When you press a button other than Learning
button, the indicator will blink. For specific
Learning buttons in specific modes, see the table
"To operate desired equipment" on page 14.
Hold down the function button to be learned on
the remote control transmitter for about 3 seconds
until the LEARN indicator goes off.
Note:
If the LEARN indicator goes off after blinking, the
supplied Remote Control cannot learn the
operating code or an error has occurred. Try steps
4 and 5 again.
Repeat steps 4 and 5 for other function keys.
8
Set the LEARN-USE switch to USE.
LEARN [dO USE
To check your programming, operate the
appropriate equipment with the supplied Remote
Control. If the equipment does not operate as
expected, repeat steps 1 to 7.
If needed, try changing the distance between the
two remote controls.
Attach the supplied template to the Remote
Control to enter the function names of the AUX
buttons you have programmed.
Use a ballpoint pen etc. to write the function
names.
To cancel the learned operating codes
1
2
3
Set the Mode selection switch to AUX.
Set the LEARN-USE switch to LEARN.
Hold down the button of the function to cancel on
the Remote Control for about 1 second until the
LEARN indicator lights up.
Hold down RECALL and RESET at the same time
for about 6 seconds until the LEARN indicator goes
off after blinking.
Note:
You cannot cancel the programming if you release
the button while the indicator is blinking.
Set the LEARN-USE switch to USE.
18