Toshiba TW56D90 - Manual (Page 23)

CHAPTER 2 GETTING STARTED
Programming Channels
• First, use the AUTO CHANNEL PROGRAM function to preset aii active channeis in your
area automaticaliy.
If necessary, arrange the preset channels with the CHANNEL PROGRAM and ADD/ERASE
functions so that you can tune into only desired channels.
AUTO CHANNEL PROGRAM function
1
2,3
4
To program all available channels automatically
(AUTO CH PROGRAM)
1 Press POWER on the Remote Control
or the TV to turn on the TV.
Press SET UP on the Remote Control
(or MENU on the TV) to display the
SET UP menu on the screen.
Press SET UP repeatedly on the
Remote Control (or
ADV on the TV)
until “AUTO CH PROGRAM" is
displayed in magenta.
Press - or + to start
autoprogramming.
The TV will automatically determine
whether the TV (antenna), STD
CABLE , HRC CABLE, or IRC CABLE
signals are being received.
Then automatically cycle through all
channels and place active channels
in the channel memory.
When autoprogramming is
complete, you will see the message
at the right.
You can check to see which channels
are in memory by pressing
CHANNEL A or T.
ANT 1
CABLE 4
SET UP
AUTO CH PFWDGRAM
ADD■ERASE
TV • CABLE
CH PROGRAM
CH CAPTION
CH LOCK
CLOSED CAPTION
TO SELECT ^ENU
PUSH SET UP
TO CCWTROL PUSH - +
OFT i IP
AUTO CH PROGRAM
ADD•ERASE
TV-CABLE
CH PROGRAM
CH CAPT1 ON
CH LOCK
CLOSED CAPTION
TO SELECT MENU
PUSH SET UP
TO CONTROL PUSH - +
AUTO CH PROGRANMING
F I N I SHED
CABLE 4
23