R,rtft, Vy vy i, Ilqlisp.lpj'r – Kenwood UD-900M User Manual

Page 73

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Be sure to adjust the present time before proceeding

the following.

Timer playback of tape

| Remote control unit oniyl

^ Switch the power ON.

Press the IPOWERI key of the power amplifier.

2 Select the program setting mode.

The program No. indicators (1 to 4) blink.

3 Select the program No. to be used.

SUN MON njE WED

fSfilS»

(Z3 CD CZ) CD

Select from 1 to 4.

Press within 8 seconds.

• The selected program No. indicator blinks.

Specify the day(s) of the week with the

numeric keys.

a m G b m m

CD CD m m czi'

J U I - C U I M

R Y

?R,rTfT;

5 Input the ON time with the numeric keys.

6:30 AM:

[^[6][3]lol

^------------------------------------

ENTER

% _

T I R E

0 Input the OFF time with the numeric keys.

7:00 AM: 0[I]i^io]

ENTER

' U P i

I F F

I F F ^ ^ J U u P r

0 Select the TAPE source.

CCi

e r r

r n I I o r r

_/ L i_ L i_ I

J U U n L. t

^ RPE

TUNER CD ^ I TAPE'

The sources are switched every time the

key is press.

Insert a tape and determine the playback

condition.

Select the side(s) to be played and the Dolby NR
mode.

( nm 1

Timer playback is possible with either Deck A or Deck

B. However, if tapes are placed in decks, playback will

begin from Deck B.

Activate the execution of the program.

S E i P L J P R O G R P f l

(

)

Select the program No. to be executed by

pressing the numeric key under which it is set.

fi QD □□

S R -

The selected program No. indicator lights up.

7 Select the PLAY mode._________________ -

C C I C

n T) r

4- BAND

_ENTER_

‘ I I U M L

, , I

Vy vy I

„ilQliSP.LPj'R

The timer modes are switched between PLAY and REC every
time the

BAND I key is pressed.

Adjust the volume and tone.

Switch the power OFF.

Press the [

power

] key of the power amplifier.

Notes:
1. When a program has previously been set in the program No.

selected in step 3, the newly-set program replaces the previ
ous program,

2. Do not operate the | CLEAR j key or | POWER] key while the

timer program execution has been activated; otherwise mal
function will occur.

To change the program

During the setting

After setting is

operation

completed

Repeat the program
ming procedure from
step 2,

UD-900/UD-900M (En)

This manual is related to the following products:

UD-900