Kenwood UD-900M - Manual (Page 64)

Recording of CD playback (OCRS)
■ Al EDIT recording
When the total playing time of a CD exceeds the re­
cording time of tape, this function allows to accom­
modate all tracks in a tape by cutting the end of each
track by means of fade-out. It is also possible to
specify the important tracks that must not be cut.
(Al PRIORITY EDIT (UD-900 only})
To apply an equalizer effect See page 60.
2 Select the CD input.
Set up Deck B ready for recording.
© Insert the cassette tape.
© Check the tape trans­
port direction.
© Select the tape sides to
be recorded.
□iRECTi^ ^ :Select two-side recording.
Í rfm~ )
® Select the Dolby NR mode.
C j
3
4
Insert the disc in the CD player.
• With the UD-900M system, close the door and make
sure the! PGM| indicator is extinguished.
Select the tracks which must not be cut in
recording.
UD-900 only:
© Press the P.MODE key.
• |PGM [lights up.
@ Input the track Nos. using the numeric keys.
• Input several numbers in a desired order.
• For details, refer to "Playing desired tracks in desired or­
der" on page 50.
Select the Al EDIT mode with the EDIT
MODE key of the CD player.
EDIT MODE P» EDIT ^ I Al EDIT! -» MULTI EDIT -,
The display changes every tinne
the key is pressed.
Proceed to the next step within 8 seconds after setting
Al EDIT. If 8 seconds have elapsed, select the Al EDIT
mode again.
With the UD-900M (DP-MA9) system, press the disc
selector key to select the disc to be recorded.
6 Input the two-way recording time of the
tape.
Use the numeric keys of the CD player.
C-30 tape: f+io] i+i^ F mo ] 0
C-46 tape: F mq I F mo ] F mo I F m ^ (D
• 46, 54, 60 or 90 can also be selected every time the
[TlM^ key is pressed. In this case, press thejEDIT MODE[
key again to establish the input.
• Tracks are edited automatically to fit sides A and B, and
the end of editing is indicated when thejAl EDlTjindica-
tor changes from blinking to continuous lighting.
7 Press the CCRS key.
Normal-speed recording
Quick blinking Slow blinking
Double-speed recording
[ OCRS HIGH I
Slow blinking
Recording occurs as shown below.(example for
the UD-900 system)
k- Programmed tracks —4
1
'' IL_!.JI
< H |< G |< F 1 <3
J
First, the programmed tracks are recorded without any
cutting, the other tracks are recorded with the end of
every track cut by fade-out. (UD-900 only)
If the tape has enough recording time, all tracks are
recorded until the end.
The CD player and cassette deck enter the stop mode
automatically after the completion of recording.
Notes:
1. If an extremely-short tape recording time is set, automatic editing may not occur.
2. ThejSPACElkey and|REPEAT|key functions are inoperative.
3. Edit operation does not occur if a track No. 44 or more has been programmed. (With the UD-900M system, programming is not possible.)
4. X. FADE recording is not possible.
64 UD-900/UD-900M (En)