Kenwood UD-900M - Manual (Page 65)

MULTI EDIT (Multiple disc edit) recording
This function allows to edit desired tracks on multiple CDs, each of which containing no more than 20 tracks, and
record them on a single tape while replacing discs.
With the UD-900M system, load the desired discs for editing into the magazine and plus-1 tray beforehand.
1 Set up Deck B ready for recording.
© Insert the cassette tape.
© Check the tape trans­
port direction.
(D Select the tape sides to
be recorded.
~Z) ;Select two-side recording.
® Select the Dolby NR mode.
3 Insert the disc in the CD player.
With the UD-900M system, close the door and make
sure thelPGMl indicator is extinguished.
A Select the MULTI EDIT mode with the
EDIT MODE key of the CD player.
EDIT MODE > EDIT A1 EDIT -> ! MULTI EDITI -
The display changes every time the
key is pressed.
Proceed to the next step within 8 seconds after setting
MULTI EDIT. If 8 seconds have elapsed, select the
MULTI EDIT mode again.
Input the two-way recording time of the
tape.
Use the numeric keys of the CD player.
C-30 tape; FTiol Lfio] f+io1 [o]
C-46 tape; f+i^ i+i^ [+1^ H]
• 46, 54, 60 or 90 can also be selected every time the
ITIMEI key is pressed. In this case, press the|EDIT MODE]
key again to establish the input.
• IMULTI EDITjchanges from blinking to continuous
lighting, indicating the program input stand-by, and the
recordable time of side A is displayed.
With the UD-900IVI system, select one of the
seven discs loaded in the player.
• To select another disc, press the [1 key while the play
track number blinks.
To apply an equalizer effect See page 60.
2 Select the CD input.
0
Select the tracks to be recorded.
Using the numeric keys of the CD player, input
the track Nos. in the order they are to be re­
corded. {on the remote control unit with the UD-
900M system)
• The TOTAL TIME display shows the remaining time on
the tape side A or B.
• When "FULL" appears on the display, this indicates
that tracks cannot be recorded any more.
7 Press the OCRS key.
Normal-speed recording
ЧI/ si/
Ji
hi in L* in S Quick blinking
Double-speed recording
Quick blinking Slow blinking
Recording occurs as shown below (example
when three CDs are to be recorded).
1
^
1 1
^ I
1
^
G
-Third CD- -Second CD-
When the first CD has been recorded, both the CD
player and cassette deck enter the stop mode. With
the UD-900 system,the tray of the CD player opens
automatically.
With the UD-900 system:
To record the second and third CDs, repeat steps 6 and 7
after changing the CDs and closing the tray of the CD player.
With the UD-900M system:
Select another disc and repeat steps 6 and 7.
Notes:
1. in step 6, the display of the CD player shows FADE and the end of the selected tune which is longer that the preset time is faded out.
2. Track No. 44 (21 with the UD-900M system) or more cannot be input.
3. The! SPACE
I key andlREPEATlkey functions are inoperative.
4. During recording, do not press the P.OPEN / CLOSE or magazine eject key. (UD-900M)
UD-900/UD-900M (En) t