Kenwood UD-900M - Manual (Page 71)

Be sure to adjust the present tíme before proceeding
the following.
Timer reception of radio broadcast [ Remote control unit oniyi
Switch the power ON. p
Press the
I
POWER
I
key of the power amplifier.
Select the program setting mode.
S E L E L T P R 0 E R H I 1
The program No. indicators {1 to 4) blink.
3 Select the program No. to be used.
-........ - -6 WEC EjSEiS.
CD CD CD CD
Select from 1
Press within 8 seconds.
■ The selected program No. indicator blinks.
Specify the day(s) of the week with the
numeric keys.
m a D D i S m
CZD CD CD CD CD '
] E L E l U R )
X>
Input the ON time with the numeric
keys.
6:30 AM: [Ó ] [6] [D ® I R P U T El U 1 111E
^ — ■ --
G G R U B - 3
Input the OFF time with the numeric
keys.
______________________
I N P U T D E E T I N E
7:00 AM: [o] [H
ENTER
■iH,
. G r F ^ jUJJ El ^OEr
0 Select the TUNER source.
) E L E l 5 U U R E E
OMJMLJ ENTcH
' t : B R
tlUNiRj ^ CD ^ TAPE
The sources are switched every time the| BAND! key is press,
• "LAST" is selected when, for instance, DBS tuner or
LD player is being recorded.
9 Select the preset key under which the
station to be received has been preset.
a a m a a
a a a s s
0- L
EMTEB \ >
The station must be preset previously.
3 3 E D -
C 1 ^ 1 V
t I'l JJ
10
Activate the execution of the program.
a ( CIIIIJ i
5 E L E E T P R U B R P N
( 2 ) Select the program I\Io. to be executed by
pressing the numeric key under which it is set.
m Q m J~j'
• The selected program No. indicator lights up.
11
Adjust the volume and tone.
12
Switch the power OFF. {; [Q
Press the I POWER! key of the power amplifier. N (
y Select the PLAY mode.
^ ^ ENTER
E E L E E T N P U E
. l I Q U E i T P L P 3
The timer modes are switched between PLAY and REC every
time the I
BAND
I
key
is
pressed.
To continue the reception of radio station which
as been started to be received by timer ON:
0 Press the CLEAR key before the OFF time comes.
( 2 ) Press the numeric key for the program No. being
executed.
• When the program No. indicator goes off, it means that
the program will be received continuously.
Notes:
1. When a program has previously been set in the program No.
selected in step 3, the newly-set program replaces the previ­
ous program.
2. Do not operate the 1 CLEAR [key or |POWER| key while the
timer program execution has been activated; otherwise mal­
function will occur.
To change the program
During the setting After setting is
operation completed
Repeat the program­
ming procedure from
step 2.
UD-900/UD-900M (En|
71