Kenwood Rack SRC-603 User Manual
Kenwood, Important safeguards, Assembly instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STEREO SYSTEM RACK
SRC-603©/ 663
ASSEMBLY INSTRUCTIONS
KENWOOD
KENWOOD CORPORATION
©PRINTED
IN U.S.A. B61-0577-00(TOCABI)
R0343
\ '
IMPORTANT:---------------------------------------------- -------------- -------------------
• Before operating your new KENWOOD product, read through this assem-
•bly manual carefully to get the most out of it.
• Save this assembly instructions.
Before Assembling
• Be sure to check that all parts are accounted for before disposing of the
packing case.
• A Phillips screwdriver and a mallet are required for assembling.
• Be carefull not to damage the floor and rack.
Notes on Assembling
• During assembling, be sure to verify the numbers stamped on the boards.
•
Mount the rear panel after assembling the side panel on the bottom shelf
at a right angle.
•
When mounting the top shelf and kick plate on the side panel, use glue
for adhesive. Be sure to remove any excess glue before it dries.
•
If the amplifier wobbles when its key switches are pressed, insert a woo
den dowel into the hole on the side panel and fix the rear of the amplifier.
Handling Precautions
• Tempered glass is used for the glass doors for providing sufficient strength.
However, pay attention not to apply excessive force or to scratch the doors.
Cracking or breaking of the glass may occur.
•
When moving the cabinet, remove all the components from the rack be
fore carrying the cabinet. Also do not grasp the top shelf when carrying.
•
To allow head radiation from the components, leave a space of 4 inches
between the cabinet and wall.
•
Do not place the cabinet in a location subject to direct sunlight or near a
heater, an air-conditioner, or a place with high humidity.
IMPORTANT SAFEGUARDS
ACautiOT : Read this page carefully to keep your safety.
o
2.
Water and moisture — Do not place a liquid container, such as a vase and
water basin, on the unit. Also avoid installing the unit in a place subject
to dampness.
3.
Heat — Do not install the unit near a source of heat, such as a heater, or
under direct sunlight.
o
Please reagl^ of the safety and operating instructions before operating this
unit. For b^^'esults, follow all warnings placed on the unit and adhere to the
operating and use instructions. These safety and operating instructions should
be retained for future reference.
1. Suffocation — After taking the unit out of the polyethylene bag, be sure
to dispose of the polyethylene bag out of the reach of children. Otherwise,
they may play with the bag, which couid cause hazard of suffocation.
4.
Impact — Avoid placing the unit on an unstable surfacr "^stall it on a
horizontal surface not subject to excessive dirt or vibrat.wi-
5. Modification — Do not attempt to open or modify the unit, for this could
cause fire hazard or malfunction.
). Cleaning — Do not use thinner, benzine or alcohol. When cleaning the unit,
wipe with a soft, dry cloth.
7. Abnormal smell — In the event the unit generates smoke or abnormal smell,
immediately switch the power OFF and unplug the power cord. After this,
please contact your dealer or nearest service station as soon as possible.
POWER OFF!