Canon W8200 - Manual (Page 58)

Print Media You Can Use
30
2-30
Aligning the Printhead
After adjusting the height of the printhead, use the operation panel to execute
“Print Pattern A”, then adjust the printhead alignment. (
Æ “Aligning the
Printhead” P.7-35)
Re-adjusting Printhead Height
After the print job is finished, especially before starting the next print with
another type of media, you must do the procedure to reset the printhead
height adjustment lever to the center(standard) position. (
Æ “Adjusting
Printhead Height” P.2-27)
After re-adjusting the printhead height position, you should once again use
the operation panel to align the printhead. (
Æ “Aligning the Printhead”
P.7-35)