Canon W8200 - Manual (Page 165)

Cleaning the Printhead
33
7-33
Cleaning the Printhead
When the ink nozzles of the printhead become clogged, you can restore
normal operation by cleaning the printhead.
Types of Printhead Cleaning
There are two methods for printhead cleaning.
THead Cleaning A
Perform when the printing is faint or when dust has collected on the
printhead. This cleaning method consumes the least amount of ink. Head
Cleaning A requires about 1 minute to complete.
THead Cleaning B
Perform when the printing is blank or when Head Cleaning A does not
correct the problem. Head Cleaning B requires about 2 minutes for the
dye ink printer and about 3 minutes for the pigment ink printer.
Printhead Cleaning Procedure
Follow the procedure below to clean the printhead. The procedure is
basically the same for both printhead cleaning methods.
• If one execution of Head Cleaning A does not correct the problem,
perform Head Cleaning B.
• If Head Cleaning B does not correct the problem, repeat Head Cleaning
B two or three times.
• If three consecutive cleanings with Head Cleaning B do not solve the
problem, then the printhead is damaged and should be replaced.
(
Æ P.6-19)
1
Press the Power button to switch the printer on.
After a few seconds “Online” is displayed in the operation panel and the
Online lamp lights.
Enter Cancel
Cut Sheet
Roll Media
Paper Source Data Message Power
Online