Casio fx-5800P - Manual (Page 126)

E-125
A Transferring All Programs
1. Perform the following operation on the receiving calculator (Receiver).
Nc1(LINK)2(Receive)
• This will put the Receiver into receive standby, which is indicated by “Receiving...” on its
display.
2. Perform the following operation on the sending calculator (Sender).
Nc1(LINK)1(Transmit) 1(All)
3. To start data transfer, press the Sender’s
E key.
• During data transfer, the screen of the Sender will show
the message shown to the right. The screen of the
Receiver continues to shows the screen that appeared in
step 1.
• After data transfer is complete, the screen of the both the
Sender and Receiver will change to the message shown
to the right.
A Transferring Specifi c Programs
1. Perform the following operation on the receiving calculator (Receiver) to put it into
receive standby.
Nc1(LINK)2(Receive)
2. On the sending calculator (Sender), perform the following operation.
Nc1(LINK)1(Transmit) 2(Select)