Brother Fax-410M - Manual (Page 91)

IV-8. USING THE UNIT A S A TELEPHONE
Using keys with the
telephone
PAUSE key- Use this key to put a pause between numbers.
(You cannot use the PAUSE key continuously.)
HOLD key- Use this key to put a telephone call on hold.
Flash key- Use this key to transfer a call and put it on hold.
# key- Use this key to switch the dialing type to "tone",
in case it had previously been set to "pulse".
Using an external
telephone
You can use the fax machine with an external telephone or with an
external TAD (telephone answering device).
Connect the external telephone as described in the "ADDITIONAL
SET UP OPTIONS" (see page III-9-1).
Using an external
telephone answering
device
Connect your external telephone answering device (TAD) to the
EXT. DEVICE jack as shown in the illustration below.
I MANUAL
— RT
\AUTOANS
Set the Auto Ans. switch to "Manual" (so that only the "Manual"
LED is lit).
The external TAD is now ready for use.
The unit will enter the document reception mode automatically
when another party tries to send a fax transmission with a CNG
tone to your machine. CNG is generated by most Group 3 FAX
machines.
If the sending party (using a tone type unit) presses your F/T &
REMOTE ID code, fax reception is switched to the main unit,
• If the ICM section of your external TAD is full, the TAD will not
answer the telephone. As a result the unit cannot receive the
transmission.
• If your external TAD has a paging function, the unit may prevent
the paging function from working.
IV-8-2