Sending – Brother Fax-410M User Manual
Page 148
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SENDING
SENDING
SYMPTOM
POSSIBLE CAUSE
ACTION
cf.
Document jam
•
Jam in the scanning section
•
Open the panel cover and
remove the jammed paper.
Close the cover (and listen for
the click).
Document not feeding
properly
•
Cover not closed securely
•
Document is too thick or thin,
too small, wet, wrinkled,
curled or torn
•
Document guide not adjusted
to document size
•
More than 20 pages of
documents in the feeder
•
Push the panel cover closed
until you hear a click
•
Use a photocopier to make a
copy, then send the copy
•
Adjust the document guide to
fit the document size
•
Set only 20 pages of the
document in the feeder at one
time
Documents are
impossible to feed
•
Documents have been
inserted in the position for
recording paper output
•
Insert the documents into the
transmission document wire
extension
III-8-1
Password transmission
error
•
Password function on
receiving end is OFF
•
Passwords do not match
•
Receiving unit has no
password function
•
Receiving unit is not a
Brother series machine
•
Contact the receiver
•
Contact the receiver to
confirm the code being used
•
Contact the receiver
•
Contact the receiver to
confirm the machine being
used
Image quality of
document is poor
•
Problem with receiving unit
•
Scanning head is dirty
•
Scanning head is bad
•
Use your fax unit to make a
test copy (If this is passable,
the problem is at the other
end.)
•
Clean the scanning head
•
Call your Brother service
center
III-8-1
VII-3
Documents sent are
received blank
*
Document is face up in the
feeder
•
Set the document face down
in the feeder and send it again
Auto transmission is
not working
•
The wrong {a non-fax)
number was dialed
•
Polled, or transmission or
redialing with a document in
the feeder is being carried out
•
Double check the fax number
you have registered in the
machine
•
Use the interrupt function
V-15-1
Delayed sending does
not work
•
The HOOK key has been
pressed or the handset was
picked up
•
Polled, transmission, or
redialing with a document in
the feeder is being carried out
•
The maximum number
(three) of delayed
transmissions have been set
up (on the FAX-500M)
•
Refer to the instructions and
begin again
•
Use the interrupt function
•
Wait until the delayed
transmissions already set
have been carried out
V-15-1
Vl-2