Brother INTELLIFAX 820MC - Manual (Page 99)

1-iii.MKn V. t;(A\7 KOL ACCESS IVI
tbbACz? t C b NTER SETTI N GS
H. OW to Use Remote Access and Control Codes
I. Call from a touch tone phone.
2
. Enter your fax machine’s number.
3. Enter your Kemote Access Code immediately after your fax machine answers
with a beep. (See page
8
-
22
.)
4. If you hear a long beep, it means your machine has received messages:
One long beep: Received FAX message(s).
Two long beeps: Received TAD message(s).
Three long beeps; Received both FAX and TAD message(s).
If you do not hear any long beeps, it means your fax machine did not receive message(s).
5. Next you will hear a series of two short beeps, during which you can enter a
Remote Control Command. (See page 8-24.)
6
. Enter a Remote Control Command.
7. After finishing one command, you can enter the next command during another
series of two short beeps.
8
. Press 90 to exit remote control.
If you perform a wrong operation, you will hear three short beeps.
If you wait more than 30 seconds during the series of two short beeps, your machine will
disconnect the line.
Remote Retrieval ______________________________________________________
If you have set your Message Center to store incoming fax messages (via FAX ONLY or COMBO
modes), you have the ability to retrieve these fax messages from any remote group 3 facsimile
machine,
Of course you can also remotely retrieve your voice messages as well from any touch tone phone.
Remote fax and voice retrieval is accomplished via remote control access commands, which are
described in the remainder of this chapter.
FOR YOUR INFORMATION
When to Press the Remote Access Code
Just after the line is connected, you should enter remote access code from any touch
tone phone. In the MANUAL mode, you can still connect by wmiting until after 20
rings, and then pressing the Remote Access code within 8 seconds.
8-2S