GE CS975SDSS - Manual (Page 49)

GEAppliances.com
Problem Possible Causes What To Do
"F-" and a number or
letter flash in the display
You have a function error code. • Touch the CLEAR/OFF pad. Allow the oven to cool for
one hour. Put the oven back into operation.
If the function code repeats. • Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error code
repeats, call for service.
“Probe" appears in
the display
This is reminding you to enter • Enter a probe temperature,
a probe temperature after
plugging in the probe.
Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
The clock is in the • See the Special features of your upper oven control section,
black-out mode.
Display flashes Power failure. • Reset the clock.
Unable to get the
display to show "SF"
Oven control pads were • The BAKE and BROIL HI/LO pads must be touched at
not pressed properly. the same time and held for 3 seconds.
Power outage,
clock flashes
Power outage or surge. • Reset the clock. If the oven was in use, you must reset
it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
"Burning" or "oily"
odor emitting from
the vent
This is normal in a new oven • To speed the process, set a self-clean cycle for a
and will disappear in time. minimum of 3 hours. See the Using the self-cleaning
upper oven section.
Strong odor An odor from the insulation • This is temporary,
around the inside of the oven
is normal for the first few times
the oven is used.
LOG appears in
the display
The Range Lockout feature • Be sure the surface unit controls are turned OFF.
is activated. Turn this feature off to use the range.
See the Range Lockout section.
Fan noise The convection fan may turn • This is normal. To maximize cooking evenness,
on and off automatically. the fan is designed to operate in both directions
with a pause in between.
Convection fan
not working
Preheat temperature » F a n will start automatically once the preheat
not reached. temperature is reached.
Drawer does not slide
smoothly or drags
The drawer is out of alignment. • Fully extend the drawer and push it all the way in.
See the Care and cleaning of the range section.
Drawer is overloaded or load • Reduce weight. Redistribute drawer contents.
is unbalanced.
Lower oven drawer
will not work
A fuse in your home may be • Replace the fuse or reset the circuit breaker,
blown or the circuit breaker tripped.
The upper oven is self-cleaning. • Wait for the self-clean cycle to finish and the oven
to cool.
Controls improperly set. • See the Lower oven drawer section.
Excessive condensation
in the drawer
Liquid in drawer. • Remove liquid.
Uncovered foods. • Cover food with lid or aluminum foil.
Temperature setting too high. • Reduce temperature setting.
Food dries out in the
lower oven drawer
Moisture escaping. • Cover food with lid or aluminum foil.
Oven drawer not fully closed. • Push drawer in until latch engages. , ^