GE CS975SDSS - Manual (Page 33)

GEAppliances.com
The gasket is designed with a gap
at the bottom to allow for proper air
circulation.
Do not rub or clean the door gasket—it
has an extremely low resistance to
abrasion.
If you notice the gasket becoming
worn, frayed or damaged in any way
or if it has become displaced on the
door, you should have it replaced.
Cleaning the Oven Door
To clean the inside of the door:
■ Because the area inside the gasket is cleaned
during the self-clean cycle,
you do not need to clean this by hand.
■ The area outside the gasket and the door liner
con be cleaned with a soap-filled
or plastic scouring pod, hot water and
detergent. Rinse well with a vinegar
and water solution.
To clean the outside of the door.
■ Use soap and water to thoroughly clean the top,
sides and front of the oven door. Rinse well. You
may also use a gloss cleaner to clean the gloss
on the outside of the door. Do not let water drip
into the vent openings.
If any stain on the door vent trim is persistent,
use a soft abrasive cleaner
and a sponge-scrubber for best results.
Spillage of marinades, fruitjuices, tomato
sauces and basting materials containing acids
may cause discoloration and should
be wiped up immediately. When surface is
cool, clean and rinse.
Do not use oven cleaners, cleaning powders or
harsh abrasives on the outside of the door.
Lift-Off Oven Door ion some models)
The door is very heavy. Be careful when removing
and lifting the door.
Do not lift the door by the handle.
To remove the door:
Fully open the door.
ll.
\2
Pull the hinge locks down toward the door
frame, to the unlocked position. A tool, such as
a small flat-blade screwdriver, may be required.
~j] Firmly grasp both sides of the door
— at the top.
Close door to the door removal position, which
is halfway between the broil stop position and
fully closed.
Lift door up and out until the hinge arm
is clear of the slot.
To replace the door:
Firmly grasp both sides of the door
at the top.
Bottom
edge of
slot
Hinge arm
With the door at
the same angle
as the removal
position, seat
the indentation
of the hinge arm
into the bottom
edge of the
hinge slot. The
notch in the hinge arm must be fully seated
into the bottom of the slot.
^ Fully open the door. If the door will not fully
open, the indentation is not seated correctly in
the bottom edge of the slot.
Push the hinge locks up against the front frame
of the oven cavity to the locked position.
Hinge ~
lock
Hinge
arm
Push hinge locks up to lock.
3"] Close the oven door.
33