beautypg.com

Carl Goldberg GPMA1956 Eagle 2 ARF User Manual

Page 28

background image

28

8.

Cut off the wire to the length in the SIDE

VIEW drawing.

9.

Referring to the above photo, insert the

bent wire end into the hole and slot in the SHORT wooden
pushrod and CA glue in place.

10.

Slide the black shrink tubing over the wire

and wooden rod assembly and shrink with a hair dryer.
Once the tubing is tightly shrunk, glue the edges of the
shrink tubing with thin CA glue.

11.

Examine the top of the fuselage and locate

the hole on the LEFT SIDE, under the covering, 1-1/2" in
front of the stab.

Study the photo. Making sure you are

working on the LEFT SIDE of the aircraft, carefully remove
the covering over the hole.

12.

Remove the mini snap link and, inserting

the pushrod assembly through the windshield opening,
thread it down into the tail section. Twist the rod so that it
exits through the hole in the top of the fuselage.

13.

Replace the mini-snap on the rod, screw-

ing it in until the end of the rod is just showing in the mid-
dle of the snap-link. Attach the snap link to the outside
hole on the control horn.

14.

Referring to the above photo, drill a 1/16"

hole in the servo wheel opposite where the nosegear
pushrod will be installed.

15.

Remove the center screw from the servo

wheel and twist the pushrod end onto the servo wheel