Carl Goldberg GPMA1956 Eagle 2 ARF - Manual (Page 27)

27
1. Collect the pieces:
(1) LONG wooden pushrod dowels with wires
attached
(1) SHORT wooden pushrod dowels with
wires attached
(2) 10" threaded rod
(2) Black shrink tubing, not shown
(2) Mini snap link
(1)
Full-scale pushrod drawing
2. Thread the snap link onto one of the
threaded rods. The end of the rod should show in the mid-
dle of the snap link.
NOTE: In the following steps, take care to match each
bend as closely as possible to the drawing.
3. Using the Rudder Pushrod Drawing #1,
place the threaded rod over the SIDE VIEW and mark the
location of the first bend next to the snap link.
4. Make a slight bend at the mark and com-
pare it to the drawing.
5. When satisfied with the bend, mark the
next bend location and make the bend accordingly.
6. Repeat the process for the next bend, as
shown.
7. Mark the fourth bend and then, holding the
wire over the TOP VIEW on the drawing with pliers, twist
the wire until it matches the drawing. Then bend the final
angle down.
PUSHROD INSTALLATION
NOTE: in the following steps, take care to match each
bend as closely as possible to the drawing.