Carl Goldberg GPMA1956 Eagle 2 ARF - Manual (Page 2)

ITEMS NEEDED TO COMPLETE
THIS AIRCRAFT
1 RADIO GUIDANCE SYSTEM (4
CHANNEL MINIMUM REQUIRED)
1 ENGINE .40-.45 2-CYCLE, AND
MUFFLER
(a 4-cycle engine is NOT recommended)
1
CA ACCELERATOR
1 2 OZ. BOTTLE CA GLUE
1 1/2 OZ. BOTTLE CA GLUE
1 20-MINUTE EPOXY
20 #64 RUBBER BANDS
OPTIONAL
1 PIECE OF MEDIUM SANDPAPER
PAINTS FOR PILOT FIGURE &
COCKPIT
HEAT GUN OR IRON (for covering
touch-up)
1/2” FOAM RUBBER
SWITCH HARNESS
2
TOOLS AND SUPPLIES
REQUIRED FOR ASSEMBLY.
ROLL OF WAXED PAPER
MODELING OR UTILITY KNIFE
WORK SURFACE (24" x70")
ELECTRIC DRILL
1/8", 1/16", 3/32" DRILL BITS
SMALL STANDARD & PHILLIPS
SCREWDRIVERS
MASKING TAPE
NEEDLE NOSE PLIERS
YARD STICK
FLEXIBLE STRAIGHT-EDGE
30-60-90° x 6"
ENGINEERING TRIANGLE
SOFT PENCIL
A FEW STRAIGHT OR "T" PINS
ADJUSTABLE WRENCH
WIRE CUTTER (DYKES)
HAIR DRYER
(OR OPTIONAL HEAT GUN)
ACID BRUSH