ALTANA Temp-Chart - Manual (Page 38)

37
4.2.2 Analysis area
The analysis of the measurement is indicated in
the analysis window. It takes place via application
of the objects: Cure Chart, Tolerance Curve, Oven,
Curing Conditions, Pass/Fail
These objects are automatically assigned if you
work with QC procedures (see section 2,7) If this is
not the case, the assignment can be made by the
Object Tabs. Here, objects already provided can be
opened, or new one‘s be created.
4.2.2.1 Critical values
The table of results consists of five columns:
Min
indicates for how long the curve
was at the minimal threshold
value
Low indicates for how long the curve
was at the lower threshold
value
Mid indicates for how long the curve
was at the mean threshold
value
Data Values Analysis Results