ALTANA Temp-Chart User Manual

Page 27

2.7 Work with QC Procedures

temp-chart-QC-Procedures are the best solution

for recurring tasks:
Most measurements are serial measurements

which have to be carried out more than once,

and it is often difficult to keep the measurement

setup, i.e. the sampling interval or the number

of sensors, identical or at least comparable. The

matter becomes even more difficult when new

parameters, such as the product type and oven

speed, the tolerance and critical values have to be

defined anew for each measurement. For these

tasks,

temp-chart-QC-Procedures are the ideal

solution because they represent „measurements“

which - as yet - have no data values but which

already contain some or even all the parameters.
Anyway, in the QC-procedure the complete

measurement setup is saved, and in addition you

can enter and save all the additional information in

the organizer, such as comments, critical values,

tolerance and reference curves, oven setups etc.,

that are already known before the measurement.

This ensures that measurements prepared with the

same procedure are really comparable.

Work with QC Procedures