KEYENCE DL-DN1 - Manual (Page 36)

3-2 I/O Communication
3-8 - DeviceNet Compatible Network Unit DL-DN1 User’s Manual (FD-MH) -
3
Co
mm
u
ni
c
a
ting
w
ith t
he FD
-M
H
s
er
ie
s
Error information list
Error ID
number
(HEX)
Error
code
(HEX)
Description Cause Corrective action
00h
01h Initialization error Error encountered during
initialization. Check the number of
connected sensor amplifiers
and the connection to the
sensor amplifiers, and then
cycle power. If the error
remains, contact your nearest
sales office.
04h Mixed connection
error A foreign sensor amplifier (i.e.,
one that is not compatible) is
connected. Remove the foreign sensor
amplifier.
06h Number-of-units error More sensor amplifiers are
connected than are permitted. Check the number of
connected sensor amplifiers.
nnh
(01h - 0Fh)
01h Error 1 for sensor
amplifier of ID num-
ber nn Head error (ErS)
Refer to the FD-MH series
instruction manual.
02h Error 2 for sensor
amplifier of ID num-
ber nn Head connection error (ErH)
03h Error 3 for sensor
amplifier of ID num-
ber nn Overcurrent error (ErC)
04h Error 4 for sensor
amplifier of ID num-
ber nn EEPROM error (ErE)
05h Error 5 for sensor
amplifier of ID num-
ber nn
(Not used)
06h Error 6 for sensor
amplifier of ID num-
ber nn
07h Error 7 for sensor
amplifier of ID num-
ber nn Backflow error (rEv)
08h Error 8 for sensor
amplifier of ID num-
ber nn (Not used)
09h Error 9 for sensor
amplifier of ID num-
ber nn Temperature lower limit error
0Ah Error 10 for sensor
amplifier of ID num-
ber nn Temperature upper limit error
0Bh Error 11 for sensor
amplifier of ID num-
ber nn Temperature sensor connection
error
(Err tEMP)
1Dh
02h/
04-07h System error An error occurred in the internal
system. Check the connection to the
sensor, and then cycle power. If
the error can not be corrected,
contact your nearest sales
office.
03h Model error There is a sensor amplifier
connected that is incompatible
with the DL-DN1. Connect a sensor amplifier of a
compatible model.
1Fh - No error - -