Cub Cadet MMZ Rider - Manual (Page 40)

Cub Cadet Commercial M60 Tank - 2002 and prior years
36
3. Loosen both of the lower hex jam nuts securing
the deck mounting eye bolts to the left deck lift
links using two 15/16” wrenches. See Figure 4.
4. Loosen the upper hex jam nuts until the top face
is flush with the ends of the eye bolts using a
15/16” wrench.
5. Rotate the cutting blades until they are perpen-
dicular to the frame of the unit.
6. Measure the distance of the right cutting blade to
the ground and record it._____
7. Measure the distance of the left cutting blade to
the ground and record it._____ See Figure 5.
8. If the right and left measurements are not equal,
perform the following steps:
9. Mark the top of each upper hex nut for a refer-
ence point. See Figure 6.
10. Rotate both upper hex nuts (equally) until the
blade to ground measurements are the same for
both the right and left side using a 15/16”
wrench.
NOTE: The upper hex nuts should be rotated the
same number of rotations.
11. Secure both eye bolts to the left lift links with the
lower hex jam nuts using a 15/16” wrench.
12. Raise and lower the deck several times and
make certain the measurements are equal.
Figure 4
Jam Nuts
Figure 5
Blade tip to ground measurement
Figure 6
Mark hex nut with reference point