Cub Cadet MMZ Rider - Manual (Page 16)

Cub Cadet Commercial M60 Tank - 2002 and prior years
12
11. Support the bottom of the skid plate assembly
from below.
12. Make certain the parking brake is released. See
Figure 4.
13. Remove the idler arm extension spring from the
left frame rail using vice grips. See Figure 5.
NOTE: Make certain the orientation of the spring
is recorded.
14. Remove the extension spring from the idler arm
and set it aside.
15. Remove both hairpins and clevis pins securing
the brake rod yokes to the brake actuation arms.
See Figure 6.
16. Engage the parking brake lever.
NOTE: The brake rod yokes will be pulled
forward and out of the way.
17. Remove the hex flange lock nuts and shouldered
hex screws securing both connecting rod ball
joints to the center belle crank assemblies using
a 9/16” socket and a 9/16” wrench. See Figure 7.
Figure 4
Parking Brake
Figure 5
Extension Spring
Left Frame Rail
Idler Arm
Figure 6
Hairpin
Clevis Pin
Brake Rod
Yoke
Brake Actuation
Arm
Figure 7
Flanged Lock Nuts
and Hex Screws
Ball Joints
Center Bell Crank
Assemblies