Cub Cadet MMZ Rider - Manual (Page 24)

Cub Cadet Commercial M60 Tank - 2002 and prior years
20
15. Remove the inner housing assembly.
16. Inspect the needle bearing in the inner housing.
NOTE: Remove and press in a new bearing if
needed.
17. Remove all of the shim washers from the top of
the reduction gear. See Figure 9.
18. Remove the reduction gear and inspect the
center needle bearing. See Figure 10.
19. Remove the brake assembly and inspect all of
the components. See Figure 11.
NOTE: The brake shoe spring is slightly bent.
Make certain it is not distorted.
20. Inspect the brake retaining dowel pins.
See Figure 12.
21. Remove the 46T ring gear.
22. Remove all three 13T spur gears.
23. Remove the output carrier assembly.
Figure 9
Shim
Washers Reduction Gear
Figure 10
Needle Bearing
Reduction Gear
Figure 11
Brake Shoe
Spring
Brake Retaining
Dowel
Pins
Brake Shoes
Brake Shaft
Figure 12
46T Ring Gear 13T Spur Gear
Output Carrier
Assembly
Brake
Pins