Cub Cadet MMZ Rider - Manual (Page 25)

Cub Cadet Commercial M60 Tank - 2002 and prior years
21
24. Remove the center snap ring securing the axle
assembly in position using snap ring pliers. See
Figure 13.
25. Press the axle assembly out of the outer ball
bearing. See Figure 14.
26. Remove the internal snap ring securing the outer
ball bearing into the outer axle housing using
snap ring pliers.
27. Push the outer ball bearing out of the housing.
NOTE: The outer ball bearing can be damaged
by the press and should be replaced.
Figure 13
Center Snap Ring
Axle Assembly
Internal Snap Ring
Ball Bearing
Figure 14
Ball Bearing
Axle Assembly
Snap Rings
28. Inspect the outer oil seal and replace it if dam-
aged or worn. See Figure 15.
29. Inspect all components of the transmission
assembly.
30. Clean the mating surfaces of both halves of the
housing assembly and prepare them for assem-
bly.
Figure 15
Oil Seal