Cub Cadet MMZ Rider - Manual (Page 13)

Cub Cadet Commercial M60 Tank - 2002 and prior years
9
Electric PTO Clutch Removal
NOTE: Prior to performing this section, the
Hydrostatic Drive Belt Removal section must be
performed.
1. Remove the hex lock nut securing the negative
cable to the right front engine mounting bolt
using a 1/2" wrench. See Figure 1.
2. Remove the hex lock nut securing the ground
wires to the left front engine mounting bolt using
a 1/2" wrench. See Figure 2.
Figure 1
Lock Nut
Negative Cable
Figure 2
Lock Nut
Ground Wires
3. Loosen the front engine mounting bolts and hex
flange lock nuts securing the engine to the frame
using a 1/2" socket and a 1/2" wrench.
See Figure 3.
4. Remove the hex cap screw, lock washer and flat
washer securing the electric PTO clutch to the
engine crankshaft using a 5/8” socket.
See Figure 4.
Figure 3
Engine Mounting Bolts
Figure 4
Hex Cap Screw
Lock
Washer
Flat Washer
Electric
PTO
Clutch