Cub Cadet MMZ Rider - Manual (Page 10)

Cub Cadet Commercial M60 Tank - 2002 and prior years
6
Spindle Removal and Disassembly
NOTE: Prior to performing this section, the Cut-
ting Deck Drive Belt Removal section must be
performed.
1. Remove the hex flange lock nut securing the
blade assembly together using a 1-1/8” socket
and a 1-1/8” wrench.
2. Remove the blade and spacer from the large hex
cap screw.
3. Remove the large hex cap screw and washer.
See Figure 1.
4. Remove all four hex cap screws and hex flange
lock nuts securing the spindle housing to the
deck assembly using a 9/16” socket and a 9/16”
wrench.
5. Press all of the spindle components apart and
inspect for wear or damage. See Figure 2.
NOTE: The bearings will be damaged by the
force of the press. New bearings should be
heated and set into position.
6. Assemble the spindle in the reverse order above.
Figure 1
Spindle Hex Cap Screws and Lock Nuts
Spindle Housing
Large hex cap screw and washer
Figure 2
Spindle Housing
Shaft Blade Spindle
Cone Bearing
Oil Seal
Ring Seal