Cub Cadet MMZ Rider - Manual (Page 11)

Cub Cadet Commercial M60 Tank - 2002 and prior years
7
Hydrostatic Drive Belt Removal
1. Pivot the seat assembly forward.
2. Remove the lock nut and hex bolt securing the
negative battery cable to the negative battery ter-
minal using a 7/16” socket and a 7/16” wrench.
3. Remove the sparkplug wires from the sparkplugs
on the engine.
4. Remove the hex insert lock nuts and flat washers
from the input shafts of the right and left hydro-
static pump assemblies using a 3/4" socket. See
Figure 1.
NOTE: There are two 4” holes above each
hydrostatic pump assembly to access the lock
nuts.
Figure 1
Flat Washer Input Shaft
Lock Nut
Access Holes
5. Remove the idler arm extension spring from the
left frame rail using vice grips. See Figure 2.
NOTE: Make certain the orientation of the spring
is recorded.
6. Remove the extension spring from the idler arm
and set it aside.
7. Remove both hex cap screws and flange lock
nuts securing the PTO clutch retension bracket
to the frame using a 1/2" socket and a 1/2"
wrench. See Figure 3.
Figure 2
Extension Spring
Frame Rail
Idler Arm
Figure 3
Clutch Retension
Bracket
Hex Cap Screws
PTO Bracket