ChemoMetec NC-100 - Manual (Page 71)

11 Appendix 3: Default settings for Yeast samples
61
11 Appendix 3: Default settings for Yeast samples
The settings below are suggested default settings for users with very high cell count. This
can be the case when Yeast fermentation samples are being analyzed using th e
NucleoCounter YC-100 instrument.
Figure 49 Suggested settings for very high cell counts in e.g. Beer or Wine Yeast
fermentation samples using the NucleoCounter YC -100.
If the multiplication factor for Non -viable samples is changed, the new value is stored and
becomes the default multiplication factor for non -viable samples as long as NucleoView is
running. This is useful when e.g. Yeast samples are analysed, since pre -dilution of e.g. 50-
500 is common.
Figure 50 Setting of the Multiplication factor to other than 1 for Non -viable samples.