ChemoMetec NC-100 - Manual (Page 15)

1 Installation
5
In the background the installation continues and when this is over the following dialogue
appears. Then hit “Finish”.
Figure 7 Installer Setup – Completed
The first time a NucleoCounter is turned on while connected to the computer, the
computer will identify the NucleoCounter as new hardware and install the drivers for it. So
the screen will show the following message.
1.2 Removal and upgrade of the NucleoView software
For removal
3
of the NucleoView software follow the directions below. If you upgrade from
NucleoView 2.0 or 2.1 these version must be removed first.
3
For removal of NucleoView 2.0 or 2.1 refer to the original manual.